Casio LK-160 User Manual page 15

4. 4
Press and immediately release it.
This enters record standby.
W a i t i n g
5.
Output the sound in the direction of the
microphone.
The Digital Keyboard will start sampling automatically,
and stop after one second.
• Sampling will not start if the volume of the sound picked
up by the microphone is too low.
• What you sample is stored as tone number 401.
S a m p l i n g
O r i g i n a l
6.
Try playing something on the keyboard.
• You can press pad 4 or 5 (
sampled sound (page E-8).
• A new sample replaces sample data currently assigned to
tone number 401. All of the old data (including short
sampled sounds) is deleted.
Flashes
Flashes
Lights
ck cl
or ) to sound the
Controlling the Keyboard Sounds
■ Short Sampling
With short sampling, you can sample up to three sounds,
each one with a duration of approximately 0.3 seconds. You
can sound the short sampled sounds using voice pads
1 through 3.
1.
Connect a microphone to the Digital Keyboard.
Refer to steps 1 through 2 under "Full Sampling" (page
E-12).
2.
While holding down
br bs bt
( , , or ) that corresponds to the tone
number where you want to store the sound.
• The relationship between tone numbers and voice pads
is shown below.
Selected Tone
Number
Pad 1
Pressed Voice Pad
(
Example: When voice pad 3 (Tone Number 404) is
selected
V o i . P a d 3
Record standby is entered when you release
W a i t i n g
4
, press the voice pad
402 403 404
Pad 2 Pad 3
br bs bt
) ( ) (
Flashes
4
.
Flashes
)
E-13