Summary of Contents for Kramer C-AFDM/AFDM
- Page 1 Kramer Electronics, Ltd. USER MANUAL Optical All-Fiber DVI Cable Model: C-AFDM/AFDM Available from 164 to 1640 feet...
-
Page 2: Table Of Contents
Contents Contents Introduction Getting Started Overview System Requirements for Setup (Hardware) All-Fiber DVI Cable Using Your Optical Installing Your Optical All-Fiber DVI Cable Avoiding Pitfalls using the Optical All-Fiber DVI Cable 4.2.1 Maintenance Technical Specifications Figures Figure 1: Optical All-Fiber DVI Cable Figure 2: Optical All-Fiber DVI Cable –... -
Page 3: Introduction
Introduction Introduction Welcome to Kramer Electronics (since 1981): a world of unique, creative and affordable solutions to the infinite range of problems that confront the video, audio and presentation professional on a daily basis. In recent years, we have redesigned and upgraded most of our line, making the best even better! Our... -
Page 4: Getting Started
Review the contents of this user manual Overview The Kramer C-AFDM/AFDM Optical All-Fiber DVI Cable is a digital high- quality graphics interface between a DVI-D source (for example, a host processor video source) and a DVI-D acceptor (for example, a display panel). The C- AFDM/AFDM consists of a transmitter and a receiver, connected by all fiber optic distribution cables with male DVI-D connectors at each end. -
Page 5: System Requirements For Setup (Hardware)
Software, if the DVI graphic controller or card is properly installed in your Operating System Note: The transmitter module of the Kramer Optical All-Fiber DVI Cable is designed to use +5V internal power supplied through a DVI pin (#14) from the graphic card. -
Page 6: Using Your Optical All-Fiber Dvi Cable
5. Turn ON the power on both the computer and the display device. You can replace any DVI cable or an Optical All-Fiber DVI Cable with another Optical All-Fiber DVI Cable by following the above procedures while the computer and display device are powered up. KRAMER: SIMPLE CREATIVE TECHNOLOGY... -
Page 7: Avoiding Pitfalls Using The Optical All-Fiber Dvi Cable
Using Your Optical All-Fiber DVI Cable If the system does not work properly after the Optical All-Fiber DVI Cable is installed, check that your computer system is capable of supplying more than 200mA. 6. If necessary, or if you prefer to do so, you can use the second AC/DC adapter, supplied with the cable, to power the transmitter. -
Page 8: Technical Specifications
Receiver: 5 VDC, <500mA; Transmitter: 5 VDC, <500mA Clamping Strength to Cable: 14kg f Operating Temperature: 0°C to 50°C Storage Temperature: -30°C to 70°C Humidity: 10% to 85% 1 Specifications are subject to change without notice KRAMER: SIMPLE CREATIVE TECHNOLOGY... - Page 9 EXCLUSION OF DAMAGES The liability of Kramer for any effective products is limited to the repair or replacement of the product at our option. Kramer shall not be liable for: Damage to other property caused by defects in this product, damages based upon inconvenience, loss of use of the product, loss of time, commercial loss;...
- Page 10 For the latest information on our products and a list of Kramer distributors, visit our Web site: www.kramerelectronics.com, where updates to this user manual may be found. We welcome your questions, comments and feedback. Safety Warning: Disconnect the unit from the power supply before opening/servicing.
Need help?
Do you have a question about the C-AFDM/AFDM and is the answer not in the manual?
Questions and answers