Garmin 500 Series Installation Manual page 84

CDI (LAT/VERT)
Selection
Max left/up
Full left/up
Center
Full right/down
Max right/down
FLAG (LAT/VERT)
Selection
Hide
View
S-FLG (LAT/VERT)
Selection
Hide
View
TO-FR
Selection
FROM
Hide
TO
SELECTED COURSE
Select 150° on the CDI/HSI that is connected to the 500 Series VOR/LOC/GS OBS inputs. The
SELECTED COURSE field should indicate near to 150° and a Calibrate to 150°? field will appear.
Selecting this field will calibrate the 500 Series to match the input source. Verify OBS operation by
checking that the course displayed on the 500 Series is within 2° of the selected course. Do this at 30°
intervals around the OBS card.
DME CHNL MODE
This configuration allows you to set the format for DME tuning data output.
Selection
King Serial
Parallel 2x5
Parallel BCD
Parallel slip
Narco 890/891
500 SERIES INSTALLATION MANUAL
P/N 190-00181-02
Verify That:
The CDI is "pegged" to the left/up.
The CDI is deflected full scale to the left/up.
The CDI is centered.
The CDI is deflected full scale to the right/down.
The CDI is "pegged" to the right/down.
Verify That:
The LAT/VERT flag is hidden.
The LAT/VERT flag is in view.
Verify That:
The LAT/VERT superflag is hidden.
The LAT/VERT superflag is in view.
Verify That:
The FROM flag is in view.
The TO/FROM flag is hidden.
The TO flag is in view.
Description
King Serial DME tuning data (not operational for MAIN software versions
2.02 and lower).
2 of 5 parallel DME tuning.
Shifted BCD (Binary Coded Decimal) parallel DME tuning (not operational
for MAIN software versions 2.02 and lower).
Slip-code parallel DME tuning (not operational for MAIN software versions
2.02 and lower).
2 of 5 parallel DME tuning, compatible with the following DME units:
Narco DME 890
Narco IDME 891
Page 5-11
Page Rev. B