Fanimation. 7. Fanimation reserves the right to modify or discontinue any product at any time and may substitute any part under this warranty. 8. Under no circumstances may a fan be returned without prior authorization from Fanimation. The receipt of purchase must ac- company authorized returns and must be sent freight prepaid to Fanimation.
– Seven wire nuts Fanimation. Substitution of parts or accessories not • Switch Cup Assembly – Phillips screwdriver, 4˝ designated for use with this product by Fanimation could • C28 Remote Control result in personal injury or property damage. Contact • Receiver Unit your retail store for missing or damaged parts.
Electrical and Structural Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of Ceiling withstanding a load of at least 27.7 kgs (50 lbs). Figure 1 depicts different structural configurations that may be used for mounting the outlet box.
Page 5
How to Assemble Your Ceiling Fan (cont’d) 6. Route wires through opening in Motor Coupling Cover. Downrod/Hanger Position Motor Coupling Cover on fan shown with open Ball Assembly side facing down. (Figure 2) Ceiling Canopy 7. Route wires through opening in Canopy. Position Canopy on fan shown with open side facing up.
How to Hang Your Ceiling Fan ▲WARNING To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before hanging. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.
How to Wire Your Ceiling Fan - C28 Remote Control If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. ▲WARNING Remote Transmitter Reciever Unit Detail Unit Detail To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
How to Operate Your C28 Remote Control 1. Operating & Using Remote Transmitter (Figure 1): Install 9 volt battery (If not using for long periods of time, remove battery to prevent damage to transmitter). Store the transmitter away from excess heat or humidity. •...
Trouble Shooting ▲WARNING For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble Probable Cause Suggested Remedy 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers.
Parts List Model #FP820CH Ref. # Description Part # Hanger Bracket Assembly APG610BL Downrod/Hanger Ball Assembly Containing: Hanger Ball Assembly ADR1X6** Downrod Hairpin Clip Clevis Pin Ceiling Canopy PG165** Motor Coupling Cover P81090** Fan Motor/Housing Assembly — Switch Cup Assembly AP82021** Remote Control Control Receiver...