Operation Beep; Canceling The Operation Beep - Brother 888-v12 Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Operation beep

Each time a key is pressed or an incorrect operation is performed, a beep is sounded.
■ For a correct operation
One beep is sounded.
■ If an incorrect operation is performed
Two or four beeps are sounded.
■ If the machine locks up, for example, because the thread is tangled
The sewing machine continues to beep for three seconds, and then the machine automatically stops.
Be sure to check for the cause of the error, and correct it before continuing to sew.

Canceling the operation beep

When the sewing machine is purchased, it is set to beep each time an operation panel key is pressed.
This setting can be changed so that the machine does not beep.
a Turn off the sewing machine.
b While holding the "-" side of
When a beep is heard, release the "-" side of the stitch width key.
a "-" side of the stitch width key
The machine is now set so that it will not beep.
Memo
● Perform the same operation to set the machine so that the operation beep is sounded.
98
(stitch width key) pressed, turn on the sewing machine.