Slant/Fin Multi/Pak 90 Installation Instructions page 3

INTERNAL SPLICE PLATE INSTALLATION INSTRUCTIONS

Cover sections may be tightly joined with internal splice plates for a neat, trim fit. They may be used instead of external splice plates.

Step 1:

After installing support brackets on the

wall at the desired height, place the cover

over the brackets and snap in place.

Step 4:

Place the next cover in place on support

brackets.

Step 7:

Continue sliding cover sections together

until a snug fit is obtained.

Step 2:

Insert the internal splice plate just shy of

the halfway slots. Slots must remain

visable and not slide under cover.

Step 5:

Slide the next cover over the internal

splice plate up to the screws, nails or

slotted screw drivers.

Step 3:

Insert screws, nails or slotted screw driv-

ers into the 2 halfway slots of the internal

splice plate to hold it in the correct loca-

tion and prevent the halfway slots from

sliding under cover.

Step 6:

Remove the 2 screws, nails or screw

drivers.