Panasonic BB-HCM381A Installation Manual page 2

2
Make a hole for a cable.
Hole for a cable
25 mm (1 inch)
65 mm
(2 9/16 inches)
3
Attach the rubbers and dents on the camera to the Ceiling
Plate A and attach them firmly.
Fit the four rubbers
in place.
4
Attach the Ceiling Plate A to the Ceiling Plate B and attach
them firmly with Screws A.
•
Install the camera so that the connecting part comes
to the front.
5
Connect all necessary cables (AC adaptor cord,
Ethernet cable, Audio/Video Cable, etc.) seeing Getting
Started and attach the Ceiling Mounting Cover.
1 Adjust the " " of the main
unit to the " " of the Ceiling
Mounting Cover.
•
Be careful not to nip the cable etc.
•
When removing the Ceiling Mounting Cover, move it in the
counterclockwise direction. Adjust both " " and let down the
main unit.
Wiring without making a hole for a cable
in the ceiling
Follow the steps 1), 3), 4) and 5). Making a hole is not necessary.
•
Remove the tab of Ceiling Mounting Cover and wire
through the notch.
•
Make a 25 mm (1 inch)
hole where is 65 mm
(2 9/16 inches) away from
the center in the plate.
Fit the two dents in place.
Four tabs
1
Fit the tabs to the holes and
move counterclockwise.
2
Attach firmly with Screws A.
Screws A (2 pcs.)
2 Move the Ceiling Mounting
Cover in the clockwise
direction until the " " of it fits
to the " " of the main unit.
Ceiling Mounting when the material of
the ceiling is mortar or concrete
1
Fit the Ceiling Plate B to the mounting position
and put marks.
2
Make holes at the marks and put plastic plugs
(customer-provided) into them.
Drill for concrete
(in case of tile,
use a drill for tile)
Note
•
When drilling into mortar, be careful of pieces of mortar
which may become loose and fall.
3
Mount the camera.
Mounting on the Table
Mount the camera at an even place on the table where
vibrations etc. are few.
•
Set the Mounting type setting to [On the table] on the
Camera Setup page (see page 80 of the Operating
Instructions on the CD-ROM).
Plastic plug
Soft hammer