Connecting A Decoder - Beko DPM 28 C7 Service Manual

Connecting a decoder

Via SCART
Make sure the TV and decoder are both
switched off.
Plug one end of the SCART lead (not
supplied) into the back of the decoder and the
other end into the SCART1 on
the back of the TV.
Switch on the decoder and the TV.
Press the AV button on the remote
control to select AV1.
Via RCA lead (optional)
Make sure the TV and decoder are both
switched off.
Plug one end of the RCA lead into the video
and audio out sockets on the back of the
decoder and plug the other end into the video
and audio in sockets on the TV.
Press the AV button repetitively and
select the AV3 mode by two scart
models or select AV4 mode by three
scart models.
Please Note
You can record from one external piece of
equipment to another via the TV by
connecting the playback to SCART 1 and the
recorder to SCART 2 or SCART 3 and
selecting AV1. You cannot watch the TV.
You can connect NTSC supported equipment
to the TV via the SCART sockets and
adjusting the colour via the PICTURE
menu.
Select TINT by using Program down
button and use the adjust the colour to
Volume up and down buttons.
R
AUDIO OUT
L
AV3
AV1
AV2
21