SECTION 1 WIRING 1.3 Wire Inside Hardware Channel (WeatherPro Only) To make the connection between the wire run in 12VDC Supply Wire 1.2 and the awning motor there is a cable run in 1.1.1 The 12VDC supply wire must be run from the hardware from the bottom to the top.
Wire To Remote Switch The remote switch is connected to the control FIG. 1.6 cont. box with three (3) 16 gauge wires. These are Pin 1 Brown, Yellow, Green for WeatherPro and Brown/ White, Yellow/White, Green/White for Oasis Elite. The switch end of the wire will be connected to the switch by means of 1/4"...
3.1.5 To check the WeatherPro remote switch 3.3 Wind Sensor Toggle Switch connection (Brown, Green, & Yellow) wire The toggle switch turns the wind sensor feature use a jumper wire and connect the Yellow on and off. When the switch is in the DISABLE to Brown.
FIG. 5.2 Programming Indicator Light Patio Awning Extend Button Programming Programming Programming Indicator Light Button Button Connect the supplied 10 ft. harness directly to 5.2 Programming Key FOB the motor plug. Not the one in the hardware. Con- The electronic board is susceptible to static nect the other end of the 10 ft.
While one person is holding onto the pull strap, 8.2 Awning Removal remove the bolt in the top of the right top casting. 8.2.1 In all instances of fabric, roller tube or The FRTA will roll in once the bolt is removed. weather shield replacement, it is neces- Walk the awning to the closed position.See FIG.
Note: Bottom brackets and back channel may be riveted. FIG. 8.3.2 Left Hand Torsion Shown Top Bracket FIG. 8.2.6 Turn FRTA Or Top Casting To Align Slots In End Cap With Pin Wire Tie 8” Wire Tie 8” Below Top Above Front Slots In Bracket...
Note: If the awning is installed on a coach, complete the FIG. 8.6.1 Top Slat “A” following steps on a step ladder with the FRTA extended two turns from the awning rail. Right Hand Drive Assembly Removal 8.4.1 When the removal of the Right Hand Drive Assembly is necessary, the left hand must 5/16”...
Re-Install Fabric On Roller Tube 8.8.3 Trim valance rope even with the edge of 8.7.1 Unfold the new fabric and lay it on top of roller tube. See FIG. 8.8.2. the existing fabric in the exact same View Shows Right FIG.
c. When motor drive assembly is prop- Left Hand FIG. 8.9.2 erly aligned as indicated in step 8.8.5b, Torsion Shown it is placed in the roller tube with the Wind In Direction Of Arrow motor slot positioned under the chan- nel with the fabric rope.See FIG.
Section 9 Wiring Diagram Wiring Diagram FIG. 9.1 Main Arm- Awning Black Right Side Pig Tail Remote for Motor Pig Tail to Switch Control Box Black EXTEND Green Brown Yellow RETRACT Pig Tail to Remote Switch Black Pig Tail to Yellow Ignition Green...