Table of Contents
Advertisement
OPERATING INSTRUCTIONS
CUSTOMER NOTICE: To perform a leak test of your gas connections, mix a 50/50 solution of soap and
water and brush around regulator and other gas connections . If growing bubbles appear, there is a
leak . Re-tighten connections . If leaks cannot be stopped do not try to repair .
Lighting the Griddle
Do not lean over the griddle while lighting . Read
instructions before lighting .
3 . Read all instructions before lighting .
4 . Push the control knob to start the gas flow
5 . Turn the control knob counter-clockwise
to activate the starter .
6 . Adjust the temperature to desired level .
7 . If ignition does not occur, turn gas off by
turning the knob clockwise and repeat
lighting instructions .
Match lighting Instructions
Do not lean over the griddle while lighting . Read
instructions before lighting .
1 . Ensure the control knob is in the "OFF"
position .
2 . Remove the griddle top .
3 . Light an 11" long match, then place the
match on the right or left side of the burn-
er .
4 . Push in and turn the control knob to the
HIGH position . Be sure burner lights and
stays lit .
Ignition Needle Placement
The ignition needle should be 3-7 millimeters
from the burner tube to create the proper spark .
The ignition needle should not touch the burner
tube .
Disconnecting the LP Bottle
Make sure your griddle is off and cool . Discon-
nect the regulator from the gas line by unscrew-
ing the collar, then unscrew the LP bottle from
the regulator .
WARNING: Turn controls and gas source or tank OFF when not in use .
CAUTION: If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and
repeat the lighting procedure . If the burner does not ignite with burner and could accidentally ignite
with risk of injury .
Control Knob
8
Advertisement
Table of Contents
