Specification; Appendix - eMachines E15T User Manual

10. Specification

LCD panel type 15 " TFT
Resolution XGA 1024 x 768 Max.
Pixel dimension 0.297mm(H) x 0.297 mm (V)
LCD display color 16.7 Million Colors max.
OSD control Auto-Tune, Contrast, Brightness, H/V Position, H-Size
Phase, Auto-Level, Color Control, OSD Position,
OSD Time-Out, Power Save Delay, Language,
Information.
Manual control Menu, Select, Adjust (▲,▼), Power.
Tilt +20°, -5°
Active display area 304.1 mm(H) x 228.1 mm(V)
AC/DC adapter Input：AC 100 ~ 240V, 50 ~ 60Hz
Output：+12 V DC.
Input signal Video：Analog 0.7 Vp-p. 75 ohms
Sync.：TTL Level, Positive/Negative, Separate Sync.
Input connector 15 Pin D-Sub.
Power management YES
Regulation
Safety：UL, CSA, CE, TÜV/GS, VCCI
EMI：FCC-B, MPRII
Dimensions 347 mm (W) x 365.4mm (H) x 159.5 mm (D).
Weight 7.55 lbs (3.42 Kgs) (unpacked)
Accessory VGA cable, AC / DC adapter, power cord.
Temperature
Operation ： 0 ~ 40°C
Storage ：-20 ~ 60°C
Plug & Play DDC 2B
※ Specifications subject to change without notice
19 ENGLISH

11. Appendix

Safety Guidelines
WARNING : This device must be operated with the original power supply, part number: HJC,
HASU05F.
CAUTION : The socket-outlet should be installed near the equipment and should be easily
accessible.
CAUTION : Use a power cable that is properly grounded. Always use the appropriate AC cord that is
certified for the individual country. Some examples are listed below:
USA ...... UL
Canada ...... CSA
Germany ...... VDE
IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The power cord set for this unit has been enclosed and been selected according to the country of
destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to
replace the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set
must meet IEC-60320 requirements and may look like (Figure A1 below):
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure
Labeled. For units that are mounted on a desk or table, type SVT or SJT cord sets may be used. For
units that sit on the floor, only SJT type cord sets may be used. The cord set must be selected
according to the current rating for your unit. Please consult the table below for the selection criteria for
power cords used in the United States and Canada.
Code Type
Size of Conductors in Cord
18 AWG
SJT 16 AWG
14 AWG
18 AWG
SVT
17 AWG
20
Switzerland ...... SEV
Britain ...... BASE/BS
Japan ...... Electric Appliance
Control Act
A2),
UL Listed, and CSA
Maximum Current Rating of Unit
10 Amps
12 Amps
12 Amps
10 Amps
12 Amps
ENGLISH