Makita DG001G Instruction Manual page 11

CAUTION:
Always install the battery cartridge fully
until the red indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Mounting the auger bit
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When installing the bit adapter to the
chuck, make sure that the bit adapter is fully inserted.
CAUTION:
When attaching the auger bit to the
bit adapter, make sure that the auger pin is locked
and inspect the auger pin for any damages.
CAUTION:
When carrying the tool, remove
the auger bit from the tool.
Installing or removing the bit adapter
To mount the auger bit, install the bit adapter in advance.
To install the bit adapter, place the bit adapter in the chuck as far
as it will go. Tighten the chuck by rotating the sleeve by hand.
Place the chuck key in the chuck hole and tighten clock-
wise. Be sure to tighten all three chuck holes evenly.
To remove the bit adapter, turn the chuck key counter-
clockwise in just one hole, then loosen the chuck by hand.
2
3
► 1 . Chuck key 2. Chuck 3. Sleeve
After use, return the chuck key to the key holder on the
tool as illustrated.
► 1 . Key holder
Mounting the auger bit on the bit
adapter
NOTE: The shape and mechanism of the auger bit
and the auger pin may vary depending on your auger
bit.
Align the hole on the bit adapter with the hole on the
auger bit.
Put the auger bit onto the bit adapter.
► 1 . Auger bit 2. Bit adapter
Fix the auger bit with the auger pin and the safety lock.
1
► 1 . Auger pin 2. Safety lock
1
11 ENGLISH
2
1
1
2