Foreword The purpose of this document is to describe how to install and configure the Neets Control – QueBec II and Neets Control – QueBec III. COPYRIGHT - All information contained in this manual is the intellectual property and copyrighted material of Neets.
Contact your local Neets reseller or distributor. • If the equipment has slots or holes in the enclosure, these are provided to prevent overheating of sensitive components inside.
- just connect your computer, and you are ready to begin! When you connect either a VGA or HDMI cable from the PC to the Neets Control – QueBec, the unit automatical- ly determines which source the PC is connected to and starts the presentation. When you are finished with your presentation and remove the cable from the computer, the projector turns off and the screen lifts.
Description USB connector System Default button Input 1 loop through (VGA in QueBec II, HDMI in QueBec III) Input 1 loop through (VGA in QueBec II, HDMI in QueBec III) Input 2 loop through connector Input 2 loop through connector...
(PC, video player etc.) and a display (projector, monitor etc.) The loop through does not modify the VGA signal content The QueBec II uses the horizontal synchronization signal in the VGA signal to detect an active connection between the source and the display.
Input 2 Loop through QueBec II and III In both QueBec II and QueBec III the Input 2 Loop through is a HDMI signal loop through. Please refer to description of Input 1 Loop through description for QueBec III as function is the same.
RS-232/IR connector The QueBec has one RS232/IR port, which can be configured to be used as either RS-232 transmitter or IR emitter. PIN 5 <-> GND IR-Emitter PIN 2 <-> Tx/IR When used as RS-232 transmiter port: When used as IR port: Connect the IR Connect the device to Tx/IR and GND, as emitter white striped wire to Tx/IR and shown above.
The QueBec accepts only 12 VDC as power source from the supplied power adaptor. If a power adaptor from another manufacturer is used Neets cannot guarantee proper function of the QueBec control system. System LED indicator The System LED indicator displays the current status of the system.
61000-6-3 VGA Loop through w. signal sensing Signal channel VGA loop through Product number Signal sensing type Horizontal sync, pin 13 Neets Control - QueBec II 310-0011 Specification QWXGA - 2048x1152 Neets Control - QueBec III 310-0012 Connector DSUB DE-15...