Wilson Electronics 082614 Assembly Instructions

Congratulations on your purchase of a Wilson Ranch Hand Trailer from TractorFab! Please read
Check your parts: Your kit should include:
 3 photo etched frames
 1 roof/rim molding
Recommended tools:
 Small side cutters
 Needle nose plyers
Step 1. Cut out main body and form
as shown below. Form up sides first,
check for squareness, then form up
front.
Step 2. Slide bottom over tabs. Push
bottom in place tightly, then fold tabs
over and glue in place.
Step 3. Cut supplied door pin down to
approx. 3/16" long, then insert into
roof as shown and glue in place.
Wilson Ranch Hand
Gooseneck Trailer
Assembly Instructions
instructions carefully before starting assembly.
 4 rubber tires
 2 axles
 CA type "super glue"
 Hand files
Step 4. Test fit roof casting.
Mark length, and trim off end.
Sand smooth, and verify roof
panel is flush.
Paint the roof panel silver. We
recommend Ace Hardware
Premium Silver spray paint, as
the can is equipped with a very
nice nozzle. Spray the rims too,
prior to removing from the roof
remnant.
When the paint is dry, glue the
roof in place, being careful to toe
in the front bulkhead panels over
the gooseneck hitch portion of
the roof piece.
Step 5. Separate the floor,
goose neck bottom sheet, and
door frame as shown below at
Rev 082614
 2 brass pins
 1 decal sheet
 Sand Paper
 Xacto Knife
the red dots. File the rough
edges as needed.
Page 1 of 3
Step 5. Install front Head
Sheet, and goose neck
bottom plate.
Step 6. Test fit rear door
frame. Small tabs fit into
notches in floor. Glue in
place.