RAVEN ENVIRONMENTAL PRODUCTS SID-10200
Thank you for purchasing a Raven Environmental Products process control instrument.
DESCRIPTION
The Raven E-10200 Sludge Interface Detector (SID) is a rugged portable field instrument specifically designed to
detect sludge density and measure sludge blanket elevation in sedimentation tanks and clarifiers. Precision
electronics and the latest IRED technology enable accurate and repeatable measurements. Operator features like
single-handed operation, belt clip and onboard cable stowage make it easy to use.
SETUP – battery installation
1. Switch power-off by depressing "O" on the POWER switch.
2. Remove 4 screws on faceplate, pull away faceplate to expose case chamber.
3. Open yellow Velcro strap and remove battery cradle from case.
4. Install the 6-AA alkaline batteries (provided) in the battery cradle.
5. Install battery cradle back in the case and fasten with Velcro strap.
6. Secure faceplate to the case with the 4 screws.
TOOL FAMILIARITY
Before using the SID in water, take a minute to observe how it works.
•
Power-on/off switch and a horn-on/off switch (power-on with the "I" side down)
•
A single lightbar segment lights up when the SID is powered-on
•
Lightbar segments increase with horn as sludge density increases
•
Horn may be muted by rotating the sounder vent or can be silenced by the switch
•
The probe sensor emits an IRED beam that is invisible and harmless
•
Low battery lamp will flash when battery replacement is due
Quick check
1. Switch-on the POWER and HORN.
2. Place your finger over one of the sensor eyes in the probe gap. All lightbars illuminate and the horn
sounds off. The horn can be switched-off without affecting the operation of the unit.
OUT OF THE BOX
OUT OF THE BOX
OUT OF THE BOX
1