Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for EverFocus EVS110
Summary of Contents for EverFocus EVS110
-
Page 1: Installation Guide
IP 99 Series EVS110 1 CH Video Server Installation Guide Copyright © EverFocus Electronics Corp, Release: Oct. 2008... -
Page 2: Product Introduction
This document shows you how to install IP99 video server step by step 1. Read the product introduction and package content 2. Read the specification and diagram 3. See hardware overview 4. Do wiring and installation 5. Do network connection Product introduction IP99 series IP products provides built-in, easy-to-use, and browser-based management software that can manage, view, record multiples IP99 cameras and video servers. -
Page 3: Package Content
Widely applicable — IP99 series provides live images on the network, it enhances functionality of traditional television system. IP99 series allows direct connection to visit remote video through standard IE, user can view local image as well as remote video any time any where. -
Page 4: Specifications
SPECIFICATIONS Video Video Format Video Input Video Compression Video Resolution Frame Rate AUDIO Audio Input Audio Format NETWORK Interface Supported Protocols Network Security Max. Client Limit PTZ Device Control RECORDING Manual Recording Motion Detection Recording Alarm Recording MOTION DETECTION & ALARM Physical Alarm I/O Notification... -
Page 5: Dimension Diagram
ENVIRONMENTAL Operating Temp. Humidity Dimension Diagram 44mm/1.76”(H) 91mm/3.64”(W) -10°C ~ 50°C / 14°F ~ 122°F 20%~80% 73mm/2.92”(W) 123mm/4.92”(D) -
Page 6: Hardware Overview
Hardware Overview Reset: loading factory default configuration by pressing the button, which is inside this hole. Please insert the keen-edged device to the hole for 10 seconds. RS485(Pelco-P/Pelco-D): RS 485 Connector functionally reserved for PTZ control. Power LED: Power LED will light up when power is ON. Ethernet RJ-45 port: Connect to LAN via this standard RJ-45 connector. -
Page 7: Installation
Video Out: Loopthrough connection to the video signal from the Video In connector. Terminated with a coaxial/BNC connector. Alarm In/Out: Connect to Alarm In/Out device. Audio In: Connect to Audio device. Installation a. Optional mount video server on the wall. And screw it on the wall firmly. Connect BNC of camera to video server BNC c. -
Page 8: Direct High Speed Connection
RS485 2. Direct High Speed Connection Direct High Speed Connection connect camera directly to modem without a router. You need to assign the IP address you obtain from internet service provider to IP camera/ Encoder. To access the camera, just type http:// IP address of your internet provider. If you have a dynamic IP address, this connection doesn’t work for you. - Page 9 3. One to one connect from PC to IP camera With a cross-over cable, you can connect directly without switch. However, only the PC connecting to camera can view the IP camera.