Diagram And Parts Description; Specifications - ION iPA02 Quick Start Owner's Manual

FULLY CHARGE THE BATTERY BEFORE FIRST USE
FOR MAXIMUM BATTERY LIFE
1. Make sure all items listed on the front of this guide are
included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING
THE PRODUCT.
3. MAKE SURE THAT YOU HAVE COMPLETELY CHARGED THE
BATTERY.
4. Study this setup diagram.
5. Place product in an appropriate position for operation.
6. Make sure all input devices such as microphones, cd players,
mp3 players, and linked amplifiers/PAs are turned off and
volume settings are set at "zero"
7. Connect all devices as shown above.
8. Connect the stereo outputs to the power amplifier(s), tape
decks, and/or audio sources.
9. Switch everything on in the following order.
audio input sources (i.e. microphones, instruments,
CD/MP3 Players)
last, any amplifiers
10. When turning off, always reverse this operation by,
• turning off amplifiers
• your mixer
• last, any input devices
Go to http://www.ion-audio.com for product registration.

Specifications

• Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz
• Output Wattage: (Peak) 22W
• Output Wattage: (RMS) 15W, 1%THD
• Frequency Response: 10Hz~ 50kHz +/- 3dB
• Bottom pole mount specifications: Standard Pole Mount
found at professional audio retailer
depth 80mm (3.15")
o
Diameter 35.5mm (1.40")
o
• Time required to fully charge the iPA02: under 12
hours
• Battery life: Over 10 hours* at full volume of the iPA02
when fully charged.
*Note: Battery life may vary based on temperature, age, and
volume usage of product.
3

DIAGRAM AND PARTS DESCRIPTION

1. Microphone 1 Balanced Input with Gain Control (1/4"
and XLR): This jack can either take a ¼" balanced or a
XLR balanced cable. An XLR Cable is included with the
microphone.
2. Instrument/Microphone 2 Input with Gain Control
(1/4"): This mono input accepts a ¼" input such as a
microphone, guitar, or other musical instrument.
3. Auxuliary/CD/MP3 input with Gain Control (Stereo
RCA): This stereo RCA input can be used to connect a CD,
MP3, or other audio source. To connect to a portable
device with a 1/8" headphone jack, you need a standard
(1/8" to RCA) adapter which is NOT included.
4. Master Volume Control: This knob controls the master
volume of the Road PA.
5. Power Adapter (IEC): Insert the included power cable
here to charge the unit. Note that the Road PA can run off
the power adapter while it simeotaneously charges the
battery. The charge indicator illuminates when the battery
is charging
6. Power ON/OFF Switch
7. Battery Level Indicator: While the unit is powered ON,
these four lights indicate the power left in the battery.
Battery life varies based on volume and usage.
8. Link Output: this ¼" jack is a stereo output to send the
mixed inputs
4