Subscribe to Our Youtube Channel
Related Manuals for Stelpro SCPT Series
Summary of Contents for Stelpro SCPT Series
- Page 1 OWNER’S MANUAL CONSTANT WATTAGE PIPE FREEZE SCPT PROTECTION HEATING CABLE THANK YOU FOR YOUR PURCHASE! NEED ASSISTANCE ? CONTACT °STELPRO’S CUSTOMER SERVICE. WWW.STELPRO.COM 1-844-STELPRO...
- Page 2 IMPORTANT INSTRUCTIONS This product is designed and manufactured to prevent water pipes from freezing. Improper installation, use or maintenance of this electrical heating cable can cause fire, electric shock or freezing of pipe. Heating cables must be installed in compliance with all national, state, provincial and local codes.
- Page 3 SELECTION CABLE LENGTH To choose the right length of pipe freeze protection cable, make sure the heating cable is long enough to run along the bottom of horizontal pipes and either side of vertical pipes (including valves) without crossing or spiralling. Never use a cable longer than the pipe you are protecting.
- Page 4 INSTALLATION TO ENSURE A SAFE AND EASY INSTALLATION, TAKE A FEW MINUTES TO READ THIS INSTALLATION GUIDE. WARNING: Always wear safety glasses during installation. ACCESSORIES REQUIRED Fibreglass or aluminum adhesive foil tape ½ in. (13 mm) thick fibreglass or equivalent non-flammable pipe insulation with vapour seal Note : Accessories are sold separately.
- Page 5 CHECKING INSTALLATION CONDITIONS 1. Before installing the heating cable, make sure that the area on and around the pipe is free and clear of sharp edges and combustible materials. Remove old heat tape before proceeding, and use the file to remove any sharp edges. 2.
- Page 6 WARNING: In compliance with all national, state, provincial and local codes, we recommend the use of a ground fault circuit interrupter (GFCI) receptacle or circuit breaker to reduce the danger of fire or electrical shock from a damaged or improperly installed heating cable. Electrical fault current caused by a damaged or improperly installed cable MAY NOT BE LARGE ENOUGH to trip a conventional circuit breaker.
- Page 7 3°C (37.4°F). It will shut the heating cable off when the pipe has been heated to a temperature of approximately 10°C (50°F). If after reading the following instructions, you still have questions regarding the installation or operation of this heating cable, contact °STELPRO customer service.
- Page 8 (other than that prescribed by °STELPRO) or a use other than that for which the unit was designed; 3) a natural disaster or an event out of °STELPRO’s control, including, but not limited to, hurricanes, tornadoes, earthquakes, terrorist attacks, wars, overvoltage, flooding, water damages, etc.
Need help?
Do you have a question about the SCPT Series and is the answer not in the manual?
Questions and answers