Step 2 Speakers - Panasonic SA-DT310 Operating Instructions Manual

2
STEP Speakers
1 Attach the stickers to the speaker cables.
Attach the speaker-cable stickers to make connection easier.
A noise filter comes attached with the speaker cables to
prevent undue influence to other equipment. Do not
FRONT L, R (4 m)
remove the noise filter from the speaker cable.
e.g.) FRONT R
Connect the noise filter side of the speaker cables to the
AV control receiver speaker terminals.
2 Connecting the speakers
Match the labels on the speaker stickers with the labels on the terminals.
FRONT R
To prevent damage to circuitry,
never short-circuit positive (r)
and negative (s) speaker wires.
FRONT L
HF: High Frequency
LF: Low Frequency
All manuals and user guides at all-guides.com
Speaker-cable stickers
Connect center, surround L and
subwoofer in the same way.
AV control receiver
Push the lever in the direction
indicated by the arrow, insert
the wire, release the lever and
press down on it lightly.
Push the lever in the
direction indicated by the
arrow, insert the wire,
then release the lever.
Copper: r
Silver: s
2 Speaker cables (4 wires, 4 m)
2 Speaker cables (2 wires, 4 m)
2 Speaker cables (2 wires, 10 m)
Copper
Silver
SURROUND L,R (10 m)
e.g.) SURROUND R
150 mm
SURROUND
CENTER, SUBWOOFER (4 m)
e.g.) SUBWOOFER
150 mm
SURROUND L
Copper: r
Silver: s
SPEAKERS
1 2 3 4 5
(6≠) (6≠) (6≠)
R L R L
FRONT HF/LF SURROUND CENTER
The subwoofer's terminals are on the bottom.
Fit the cables into the slots provided.
Speaker cable
From the rear
Copper
Silver
Copper
Silver
Sheet of speaker-cable
stickers
Twist the same colored wires
together.
150 mm
SURROUND
R ch
R ch
3
150 mm
SUB
SUB
WOOFER
WOOFER
6
SURROUND R
SUBWOOFER
CENTER
+
6
-
(3≠)
SUBWOOFER
From the side
7
RQT6924