Page 2
• Do not install if product has any visible damage. • Do not modify or disassemble this product beyond instructions or the warranty will be void. • Use only non-dimming class 2 constant voltage LED power supply. THIS GUIDE APPLIES TO: ALSO CHECK OUT: AL-CTLR-RGBW-4CP AL-CTLR-RGBW-4ZRF-WMT AL-CTLR-DIM-4ZRF-RMT AL-CTLR-CCT-4ZRF-RMT AL-CTLR-RGBW-3ZRF-WMT...
Page 3
MULTI-ZONE CONTROLLER INSTALLATION GUIDE Before you begin Before beginning any electrical work, always We know how boring it can be to read instructions, so we’ll disconnect power at the fuse or circuit breaker. keep this installation guide as short and sweet as possible. Before you begin with your installation, be sure to fully read these instructions.
Page 5
Handheld remote 12VDC or 24VDC Non-Dimmable Power Supply light fixture(s) AL-CTLR-RGBW-4CP (listed on page 2) (don't worry you'll still be able to dim) (one for each zone) Install your light fixture and run the wires to where you’re locating your power supply and controller/receiver.
Page 6
MULTI-ZONE CONTROLLER INSTALLATION GUIDE Pair the receiver to the remote or wall unit. a. Turn on the controller . On the handheld remotes, the light will turn on. b. Press the zone button on the remote for the zone you wish to associate. If only 1 zone, choose zone 1. zone buttons c.
Page 7
MULTI-ZONE CONTROLLER INSTALLATION GUIDE Troubleshooting • Your remote needs batteries. • Your wall mount controller has a poor connection or reversed polarity at the power supply or at the My remote won't turn on wall controller. Try reinserting or swapping positive and negative wires. •...
Need help?
Do you have a question about the AL-CTLR-RGBW-4CP and is the answer not in the manual?
Questions and answers