Advertisement
RX8D / RX8TD
Parts and Functions
1.
LCD
2. DOWN button
3. UP button
4. SET button
Channel Synchronising of the Receiver and Transmitter
Sync Channel from Beltpack or Handheld Transmitter Ú Receiver
1.
Press the synchronising button
of the transmitter.
Sync Channel from Receiver Ú Beltpack or Handheld Transmitter
1.
Press the SYNC button of the
receiver.
If it doesn't work, check that you have the IR sensor panels aligned, that they are facing each other, devices are within
10~30cm of each other, and try again.
PAGE 2
5. IrDA synchronising button
6. Power switch/volume control
7.
IR sensor area
8. RF signal meter
First turn on the power and the LCD display will show last stored channel and frequency. Select
a channel that corresponds to the transmitter. When transmitter is turned on, the A/B diversity
antenna indicatorvwill appear to denote that it is connected.
Align infrared areas of the receiver and transmitter within 10~30cm.
2.
The transmitter's LED will
illuminate to denote
synchronising signal transmitted.
HANDHELD
HANDHELD
BELTPACK
2.
The transmitter's LED
will illuminate to denote
synchronising signal received.
HANDHELD
9. Diversity A/B antenna
10. Transmitter battery power
11. Audio signal meter
3.
The channel number on the
receiver's LED will become the
same as the transmitter's, which
means the receiver has been
successfully synchronised.
BELTPACK
3.
The channel number on the
transmitter's LCD will become
the same as the receiver's, which
means the transmitter has been
successfully synchronised.
BELTPACK
OPERATION MANUAL V1.0
Advertisement
