Shop-Vac Shop-Air 309D Series User Manual page 5

1. To use the unit, place it in the area most suitable for your application. Several factors need to be
considered; the unit must have a minimum of 3 feet of clearance on both the intake and exhaust sides
of the fan to allow for proper airflow. The unit should not be placed where it can become a tripping or
safety hazard.
2. Plug the unit into the wall.
3. Turn unit on and select air speed by
plate on rear of the unit.
4. When you no longer need the unit, turn the unit off and follow the instructions for storage in this manual.
WARNING
ACCIDENTALLY STARTING, UNPLUG POWER CORD BEFORE CLEANING.
The outside of the unit may be cleaned with a damp cloth to remove any dust or residue.
USER SERVICING INSTRUCTIONS
WARNING
ATTEMPTING TO SERVICE OR REMOVE ANY COMPONENTS.
Do not attempt to service your fan beyond that described in the user manual. For all other servicing,
follow instructions under Warranty Section.
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
1. Before storing the unit, it should be cleaned. For cleaning instructions,
refer to the cleaning section in this manual.
2. Wrap the power cord around the cord hooks located on the rear grill
of the unit, to keep it untangled. THE FAN SHOULD BE STORED
INDOORS.
PROBLEM
Will not start
SET UP AND OPERATION
O = OFF, II = HIGH SPEED, I = LOW SPEED
CLEANING
–
TO REDUCE THE RISK OF INJURY FROM THE FAN
–
BE SURE TO DISCONNECT POWER SUPPLY BEFORE
LUBRICATION
STORAGE
TROUBLESHOOTING
POSSIBLE CAUSES
1. Power cord not plugged into
outlet
2. No power at the outlet
3. Defective switch or motor
, located on the motor switch
SOLUTION
1. Plug cord into outlet
2. Plug cord into another outlet
3. Contact Shop-Vac
customer service
®
PAGE 5