Page 2
Orderman GmbH. P3. 500-812 V2.0 Orderman assumes no liability for injuries or losses resulting from the use of these instructions. Orderman assumes no liability for losses or claims by third parties resulting from the use of Orderman devices.
1.2. General safety information Caution: The Orderman dual charger does not contain any parts to be serviced by the user and therefore must not be opened. If opened, the warranty is rendered null and void. Do not expose the unit to extreme weather conditions such as rain, hail, strong sunlight or snow.
Safety information 1.3. Safety information for battery pack Warning: Only use the Orderman battery model. Do not subject the battery to extreme heat. Never short-circuit the contacts since there is an explosion hazard. 1.4. Maintenance To clean the housing of the unit, use a soft cloth moistened in a mild solution of cleaning agent and water.
Startup Connect the dual charger as shown above. The output voltage for the power supply is 5V. (Output of power supply 5V). Only use the Orderman power supply. Once the dual charger is connected to power, the self-test will begin. Both LEDs on the device will flash red briefly and then green.
Orderman Dual Charger Sol Charging the battery pack Insert the batteries in the charger as shown above. You can charge one unit individually or both units in parallel. The recharging time is approx. 5 hours and 30 minutes.
Page 8
Orderman Dual Charger Sol The following LED displays may be shown: Solid green Charging completed Flashing green Unit is charging Solid red Battery is defective Flashing orange Charging interrupted briefly 8|10...
Technical data Technical data Power supply unit: Input voltage 100VAC to 240VAC, 50-60Hz Output voltage: 5VDC / 1.0A Dimensions: 110 x 67 x 135 mm Charging time: approx. 5 hours and 30 minutes Weight (w/o batteries): 360g ...
Page 10
If lithium ion batteries are defective/damaged, the escaping vapors may pose a risk to health. Use only an original Orderman battery pack. When using a battery that is not compatible with the model, there is a risk of explosion.