1. Manuals
  2. Brands
  3. SNAP Manuals
  4. Home Theater System
  5. Violet3D
  6. Learning procedure

SNAP Violet3D Learning Procedure

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

VIOLET3D-APP NOTE 4
Violet3D 5.1 Learning Procedure
© SNAP Networks Pvt. Ltd 2012. All Rights Reserved.
SNAP Networks Private Limited.
Regd. Office: 3597, 5th Cross, 13G Main, HAL 2nd Stage, Bangalore – 560 008, India
R&D Office: #734, 1st Floor, 12th Cross, 22nd Main, J.P Nagar 2nd Phase, Bangalore – 560 078, India
Phone/Fax: +91 80 2658 6459. Email: snap@snap-networks.com. Web: www.snap-networks.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Violet3D and is the answer not in the manual?

Questions and answers

Summary of Contents for SNAP Violet3D

  • Page 1 VIOLET3D-APP NOTE 4 Violet3D 5.1 Learning Procedure © SNAP Networks Pvt. Ltd 2012. All Rights Reserved. SNAP Networks Private Limited. Regd. Office: 3597, 5th Cross, 13G Main, HAL 2nd Stage, Bangalore – 560 008, India R&D Office: #734, 1st Floor, 12th Cross, 22nd Main, J.P Nagar 2nd Phase, Bangalore – 560 078, India...
  • Page 2 Violet3D 5.1 System Learning Set Up Set up for Speaker, Transmitter and MIC: 1. Power on the transmitter. If it is in standby mode switch on using remote control. 2. Make sure that the microphone is connected properly with the transmitter by observing the mute LED blinking orange.
  • Page 3 After the initial learning process, only the volume settings can be changed as per the user’s convenience. Hansong Sub Woofer (old Wireless Sub Woofer): For Hansong subwoofer, connect to power source and the subwoofer is ready for learning. SNAP Networks Private Limited.
  • Page 4 Maintain silence until the orange status LED stops blinking. Step 9: You will hear set of r You will hear set of rapid tones (sweeps) from all speakers and the s the subwoofer one after the other. SNAP Networks Private Limited.
  • Page 5 After the successful learning, d After the successful learning, disconnect the MIC, Release the wings and Release the wings and • keep in the box. The system is ready for normal usage. he system is ready for normal usage. SNAP Networks Private Limited.
  • Page 6 Blinking of red status LED and D2 for 10 sec and going to standby mode indicates that, the MIC has damaged. Select Source ‘6C’ and Repeat the learning process. Still problem continues contact Violet3d technical support. ERROR 3: Blinking of red status LED and D1 for 10 sec and going to standby mode indicates that, the noise in the room is too loud for learning.

Table of Contents