Advertisement
PRODUCT INSTALLATION AND OPERATION INSTRUCTIONS
Please pay attention to place your light in a non-shaded place with sufficient
sunshine provided for its operation.
Installation instructions
Please remove the protective cover from the Polycarbonate LED dome.
Please drill the central hole of the light (A) on the wall at the chosen
location. The central hole marked with A is located at the lower part of
the light's rear console in the middle. Please push the wall anchor in the
hole, and position the light in place. Drive the screw, and fix the light, but
do not drive the screw entirely, leave a tiny distance between the wall and
the light, so you can rotate it easily without scratching the back of the light.
Adjust the light to horizontal position by a spirit level, then mark the B and
C spots for drilling on the wall. B, and C are located at the top of the light's
rear console, at the left, and right end. Before drilling hole B, and C, please
unscrew A while holding the light, remove it from the wall, and place it in
a safe place. Drill the holes for B, and C, and push the wall anchors into
the holes.
Place the light in position, and drive the 3 screws to fix your light.
Operational instructions
1. Turn on the light by pressing the ON/OFF
button located on the side of the light.
2. Pay attention to locate the light in a
vertical place where sufficient sunlight
is provided daytime to charge your
light. Charging by solar energy will start
automatically during daytime.
3. The light sensor turns on your light at
dusk, and keeps it at full power (20W) for
5 hours (considering sufficient battery
charge)
4. After 5 hours the light switches to power-
saving mode operating at 25% capacity
(5 W) until dawn (considering sufficient
battery charge). In the morning the light
sensor turns off the light, and reactivates
charging mode.
5
Advertisement
