Advertisement
Available languages
Available languages
2.11
Meaning of elements, located on the power distribution unit (PDU)
1. VDE cable with IEC C14 plug (models with the IEC indication in
the product name) or with French plug, at the end of cable,
2. French plug of the input cable,
3. IEC C14 plug of the input cable (only models with IEC indication
in the name),
4. Mounting brackets intended for fixing the strip in the ICT server
rack / 19" / 10" rack,
5. Power switch. If the side of the switch with the white circle icon
is tilted upwards, it means that the strip is turned off. If this half is
tilted the opposite way, it means that the strip is turned on.
6. Surge protection LED. If the LED is green, the protection is active.
7. Schuko socket,
8. French socket / 230V PL,
9. IEC C13 Socket.
10. The electric path is follows: L (phase wire) – red, N (neutral wire) – blue, G (ground wire) – yellow.
3. Assembly within ICT rack / 19" / 10" rack cabinets
1. Select 1 unused 1U slot on the vertical mounting rails of the ICT rack / 19" / 10" rack and align those holes with the holes found on the
power distribution unit (PDU).
2. Insert up to 4 metal baskets, bent at the end, with mounting basis inside them, into up to 4 designated holes (mentioned in point
(1)), in such way, so the bent ends of metal baskets will slide, click into and grab the designated holes on the vertical mounting rails,
from the outside.
3. Enter up to 4 screw washers and then insert and screw up to 4 M6 screws from the outside through the selected holes (point (1)) of
the vertical mounting rails.
4. Connecting and disconnecting the PDU and connecting and disconnecting the devices to or from the PDU
1. To connect the power strips to the mains or the UPS, insert the plug of the input cable of the switched off power strip into the
appropriate socket of the power source, which will correspond fully to the specification of the PDU's plug. Then turn on the strip by
switching the switch to the "ON" position – only PDU for 19" racks. In the case of PDU 03 series (intended only for assembling in 10"
cabinets) connecting the plug of PDU to the source power socket will cause the current will appear on PDU output sockets.
2. To disconnect the power strip, turn it off first, and then remove the plug of the input cable from the source power outlet – only PDU
for 19" racks. In the case of PDU 03 series (intended only for assembling in 10" cabinets) turn off the connected devices and pull out
their plugs from the outlet sockets of PDU, and then pull out the PDU plug from the source power socket.
3. To connect an external device to the terminal, insert the plug of this device in its appropriate socket, which will correspond fully to
the specification of the plug of the output socket of the strip.
4. To disconnect the external device from the PDU, remove the plug from its socket by switching off, beforehand, the external device (if
it is possible).
1
2
Lanberg © 2015-2019
6
7
8
5
3
4
9
Advertisement
