Shutting Down The Projector - Epson PowerLite 703c User Manual

Focusing and Zooming Your Image
Rotate the focus ring to sharpen the image.
Use the tab to rotate the lens ring and reduce or enlarge the
image.
You can also change the image size by moving the projector
closer to or farther away from the screen. You can use the
button on the remote control to zoom in on a portion
E-Zoom
of the image. See page 5 for instructions.
Adjusting the Height of Your Image
If the image is too low, you can raise it by extending the
projector's feet.
1. Stand behind the projector. Pull up the blue foot release
levers and lift the front of the projector. This unlocks the
feet.
Caution: Do not hold the projector by the lens; this can
damage it.
2. Once the image is positioned where you want it, release the
levers to lock the feet in position.
3. To fine-tune the height of the image, rotate the thumb
wheels attached to the projector's feet.
If the image is no longer square after raising it, see the next
section.
Adjusting the Image Shape
If the projected image isn't square or has a "keystone" shape,
do one or more of the following:
❏ If your image looks like
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely.
lens ring
tab
focus ring
or , you've placed the
EPSON PowerLite 703c Projector
❏ If your image looks like
of the button to correct the shape of the image.
Keystone
After correction, your image will be slightly smaller.
You can also perform electronic keystone correction using
the projector's Setting menu.

Shutting Down the Projector

When you've finished using the projector, follow the
recommended procedure to shut it down. This extends the life
of the lamp and protects the projector from possible
overheating.
Note: When the projector has not received any input signals for 30
minutes, it automatically turns off the projector lamp and enters
"sleep mode." This conserves electricity, cools the projector, and
extends the life of the lamp. If you are done using the projector,
unplug the power cord. If you want to start projecting again, press
the button.
Power
1. If you're using a computer, shut it down first.
2. To turn off the projector, press the red
projector or remote control. You see a confirmation message.
(If you don't want to turn it off, press any other button.)
Power
button
3. Press the button again. The power light flashes
Power
orange for about a minute as the projector cools down.
When the projector has cooled, the orange light stays on and
the exhaust fan shuts off.
If you want to turn the projector on again, wait until the
orange light stops flashing. Then press the
4. Replace the lens cap, retract the lens, and unplug the power
cord.
Caution: To avoid damaging the projector or lamp, never
unplug the power cord when the power light is green or
flashing orange.
5. If you're using a VCR or other video source, turn it off after
you turn off the projector.
6. Disconnect all equipment, and store the projector in the bag
that came with it or in a protective case.
2/01
or , press the
Power
Power
EPSON PowerLite 703c Projector
or side
+ –
button on the
power
light
button.
- 5