Epson PowerLite 600p Quick Setup

C
onnect the projector
to your laptop
For most setups, you'll need just these two cables:
power cord
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer cable to the
Computer/Component Video port on the projector.
3
Connect the other end to your laptop's video
or monitor port.
P
lug in your projector
Connect the power cord to your projector and plug the other end into a grounded outlet.
T
urn on your equipment
1
Remove the lens cover.
2
Turn on the projector first. To do so, press the red Power button.
The power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
3
Turn on or restart your laptop. (Windows
New Hardware Wizard screen for a Plug and Play monitor, click Cancel.)
computer cable
®
only: If you see a
Caution: Before unplugging the projector...
Press the red Power button twice, then let the projector cool while the
light flashes orange (about a minute and a half). Once the light stops flashing
and stays on, it's safe to unplug the projector.
Never unplug the projector when the
EPSON ® PowerLite

Quick Setup

Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User's Guide.
power light
power button
power light is green or flashing orange.
Turn over
® 600p/811p/820p
power