SAFETY WARNING For your safety, please read the following contents carefully before using this dehumidi er. Requirements: • Install this humidi er in smooth place to reduce vibration and noise. Keep a distance of at least 50cm between appliances and surroundings. •...
Prohibition: • Please do not place this dehumidi er close to heating devices ( ame or heaters, etc.). • Please do not turn on or turn o this dehumidi er by plugging in or pulling out the plug. • Do not use insecticide spray or other ammable substances in the vicinity of this dehumidi er.
INSTALLATION • Drain the water tank before use. • Refrain from opening doors/windows during operation. • When the dehumidi er is installed, a certain space must be reserved around this dehumidi er, the minimum distance above is 50cm, and the minimum distance in front/rear and left/right is 20cm as required, as shown in gure below.
Page 6
lter frame HEPA lter 2. Hidden 88 display The hidden status is synchronized with the top digital display. hidden 88 display www.SereneLifeHome.com...
COMPONENTS Front Control panel Front panel water tank cover Water tank Rear Panel handle Water tank Back Handle Filter frame Draining Port Power cord storage column Caster www.SereneLifeHome.com...
CONTROL PANEL 1. Timer: 24h timer setup, press this key to set ON/OFF time of the dehumidi er, the setting range is 1-24h, every press adjusts one hour. If you want to cancel timer setup, press twice continuously after con rmation of setting time. 2.
OPERATING METHODS Description of Functions SETTING TIMER OFF When the dehumidi er is running, press the [Timer key] to adjust time from 1h to 24h, press the key once to increase the setting time by 1h, after the setting time exceeds 24h, the gure returns to 1 to start cycle.
How to stop: 1. Press the key again to cancel drying in dehumidi er, and recover to the running state before start of drying. 2. Press the [Power key] to stop drying in dehumidi er and recover to the standby state.
Page 11
2. Continuous Drainage: if you do not want to drain water in the water tank frequently, you can connect a drainage pipe (with inner diameter 9mm) at the back of the dehumidi er to drain water. • Locate the drain outlet at the back, unscrew the drain cover, and pull out the water plug.
MAINTENANCE Precautions: • Please disconnect power supply before maintenance or repair to prevent electric shock. • If the dehumidi er will not be used for a long time, please disconnect power supply. • Please do not clean the dehumidi er body with chemical solvents such as alcohol, gasoline and benzene, etc.
TROUBLESHOOTING If the following problems occur to the dehumidi er, the following solutions can be adopted. Symptoms Possible reasons Solutions Plug the power cord properly Power cord is unplugged into the power socket. Drain water from the water The unit does not The water tank is full.
FEATURES: • E cient Moisture Removal • Intelligent Humidity Control • Unique Modern Design • Automatic Continuous Operation • User-friendly Operation • With High-E ciency Compressor and Fan • 1-24 Hours Auto ON/OFF Timer • Auto Shuto when Water Tank Full •...
Page 15
TECHNICAL SPECS: SLDEHU30 SLDEHU50 Rated Current 3.1A Room Capacity Up to 1500 sq.ft. Up to 3000 sq.ft. up to 30 Pints up to 50 Pints E ective Dehumidifying for Rooms and 700 Sq. ft. and 1000 Sq. ft. High-Powered Power Output...
Page 16
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.com...
Need help?
Do you have a question about the SLDEHU30 and is the answer not in the manual?
Questions and answers