Sinclair SP-45AN User Manual page 5

Operation guide
Power on/off
Press the "Power" button to turn on/off the unit.
Filter time counter
When power is on, the air purifier starts to count the life of filters - it will continue
to count with every power on from where it was left off. After reaching 2000 hours,
the Reset LED will flash to indicate that a replacement is needed.
Press "Reset" button for 3 seconds, after 'beep' sound, LED will off.
After filter is replaced - Press "Reset" button for 5 seconds, after 3 'beep' sound,
LED will off and time counter will restart on the new filter.
Negative Ion
When power is on, press "Ionizer" button, the ionizing function will start, LED will on.
Press button again to switch off.
Timer
When power is on, press "Timer" button to enable purifier to switch off at
designated time. Timer range activate in an order: [
Speed setting
When power is on, press "Speed/Mode" button to set a speed from 6 selection.
Speed range activate in an order: [ 1 2 3 Sleep Turbo Auto ]
Speed/Mode Speed/Mode
Sleep Sleep
Turbo Turbo
Auto Auto
Speed/Mode Speed/Mode
Sleep Sleep
Turbo Turbo
Auto Auto
OFF ]
Speed/Mode
Sleep
Turbo
Auto
Speed/Mode
Sleep
Turbo
Auto
Kid-lock function
When power is on, press "Reset" + "Speed/Mode" buttons at the same time for 3 seconds
to activate lock function. LED at power button will flash every 0.5 seconds, at this time
any other buttons will not work.
Press "Reset" + "Speed/Mode" buttons at the same time again for 3 seconds to remove
lock function. LED will return to normal and buttons will work.
Operation guide