Epson EX3200 User Manual page 72

note
You can also use the remote
control's button to
Auto
automatically reset the
projector's Tracking, Sync,
and Position settings. See
page 101 for details.
note
You can adjust the
setting for
Progressive
signals from the HDMI
input port (excluding digital
RGB) or component video
only when 480i/576i/1080i
signals are being input
(EX5200/EX7200 only).
The HDMI Video Range
setting cannot be set for
digital RGB signals
(EX5200/EX7200 only).
Fine-Tuning the Projector
72
2. Adjust the desired options as needed:
■
Auto Setup
Leave this setting
images. Turn it off if you want to save adjustments you have
made to the Tracking, Sync, and Position settings.
■
Resolution
Set to to have the projector automatically identify the
Auto
resolution of the input signal. If necessary, select
widescreen images) or
■
Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■ Sync
Adjust this value if computer images appear blurry or flicker.
■
Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the arrow
buttons to center it.
■ Progressive
For composite video, S-Video, component video, and certain
signals from the HDMI port only (EX5200/EX7200 only).
Turn this setting on to convert interlaced signals into
progressive signals (best for moving images). Leave the setting
for still images.
Off
■
HDMI Video Range
When you connect to the HDMI input port, set the
projector's video range to match the video range setting of
your device.
■
Input Signal
If the colors don't look right on the
setting for the type of equipment you've connected to the
Computer (Component Video)
computer or RGB-video connection, or
device that outputs a component video signal (with
connectors labeled Y/Cb/Cr or Y/Pb/Pr).
to automatically optimize computer
On
(for 4:3 ratio images).
Normal
(EX5200/EX7200 only)
Auto
port. Choose
(for
Wide
setting, select the
for a
RGB
for a video
Auto