Reinforcement Stitching; Triple Stretch Stitching; Bar Tack Stitching - Brother 888-E35 Operation Manual

UTILITY STITCHES
X The feed dogs are lowered.
5
Turn on the sewing machine, and then select
a stitch.
6
Use both hands to hold the fabric taut, then
move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of sewing.
7
After sewing is finished, slide the feed dog
position lever to
to raise the dogs.
• Normally, the feed dog position lever is
positioned at
REINFORCEMENT
STITCHING
Reinforce points that will be subject to strain, such as
sleeve holes, inseams and pocket corners.
Stitch Name Pattern Presser Foot Pattern No.
Triple stretch
stitch
Bar tack stitch
CAUTION
• Be sure to turn off the main power before
replacing the presser foot. Otherwise, injuries
may occur if the foot controller or
stop button) is accidentally pressed and the
machine starts sewing.
44
1 Pattern
and turn the handwheel
.
J 03
A 45
(start/

Triple stretch stitching

Use triple stretch stitching to reinforce sleeve holes
and inseams.
1
Attach zigzag foot "J".
2
Select stitch .
3
Start sewing. (Refer to page 26.)

Bar tack stitching

Bar tacks are used to reinforce points subject to
strain, such as pocket corners and openings.
As an example, the procedure for sewing bar tacks at
pocket corners is described below.
1
Determine the desired length of the bar tack.
Set the button guide plate on buttonhole foot
"A" to the desired length. (One division on the
presser foot scale is 5 mm (3/16 inch).)
1
2
• A bar tack with a maximum length of about
28 mm (1-1/8 inches) can be sewn.
2
Attach buttonhole foot "A".
3
Select stitch .
4
Position the fabric so that the opening of the
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
Pass the upper thread down through the hole
in the presser foot.
1 Presser foot scale
2 Length of bar tack
3
3 5 mm (3/16 inch)
1
1 2 mm (1/16 inch)