Classic Car Series : 03
Write the number of each part on the reverse side of the part in pencil upon
cutting it out, to be sure you can tell which part is which later.
Before gluing, crease the paper along mountain and valley fold lines. Trace
along the folds with a ruler and an exhausted ballpoint pen (out of ink) to get a
Make sure rounded sections are nice and stiff.
Key to symbols
Cut a notch
along this line.
Cut a notch
Assembly Instructions : Six A4 sheets (No. 1 to No. 6)
Build this model with careful reference to the Assembly Instructions.
View of completed model
* This model was designed for Papercraft and may differ from the original in some respects.
Fold so that the printed pattern faces outside.
Fold so that the printed pattern faces inside.
Cut along the center of the line.
Cut these areas out.
Ruler, set square
Glue (Wood glue or craft glue recommend)
Exhausted ballpoint pen (out of ink)
Toothpicks (for use in applying glue)
Tweezers (useful for handling small parts)
Dots indicate parts to be glued;
Glue parts with the same number together.
Glue areas within the same part together.
Glue to the reverse side of the specified part.
Glue reverse side to reverse side of other part.
Glue, scissors and other tools may be dangerous
to young children so be sure to keep them out of
the reach of young children.
dotted lines indicate approximate area for
application of glue.