Hyundai E425 User Manual page 22

This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation.This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interfernce to radio communications. However,
there is no guarantee that interference wiill not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interfernce to radio or television reception,
----Reorient or relocate the receiving antenna.
----Increase the separation between the equipment and receiver.
----Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
----Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR)
Information
SAR tests are conducted using standard operating positions accepted by the
FCC with the Phone transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the highest certified
power level, the actual SAR level of the phone While operating can be well
below the maximum value, in general, the closer you are to a Wireless base
station antenna, the lower the power output.Before a new model phone is a
available for sale to the public, it must be tested and certified to the public, it
must be tested and certified to the FCC that it does not exceed the exposure
limit established by the FCC, Tests for each the FCC that it does not exceed
the exposure limit established by the FCC, Tests for each required by the FCC.
For body worn operation, this model phone has been tested and meets the
FCC RF exposure guidelines when used with an accessory designated for
this product orwhen used with an accessory that contains no metal and that
22
FCC Statement