Table of Contents
Advertisement
Connecting antenna or cable / satellite set-top box
Be sure your antenna or another device is connected properly
before plugging in the AC power cord.
If connecting to an antenna through an RF cable
Any DTV programs that are broadcast in your area can be received
for free through an antenna connection.
Antenna
IN
If connecting cable / satellite set-top box using an RF cable
If the TV is connected to a cable / satellite set-top box via a coaxial
connection, set the TV to channel 3/4 or the channel specified by
the service provider.
Antenna
IN
RF cable
If connecting cable / satellite set-top box using an HDMI
cable
If the TV is connected to a cable / satellite set-top box via an HDMI
cable, make sure you select the correct source by using SOURCE.
IN
HDMI cable
If connecting cable / satellite set-top box using component
video input
If the TV is connected to a cable / satellite set-top box via
component video input, make sure you select the correct
component video source by using SOURCE.
IN
(Y/Pb/Pr) video
IN
Audio (L/R) cables
Cable
OUT
RF cable
RF cable
IN
OUT
Set-top box
RF cable
IN
OUT
Set-top box
Component
RF cable
cables
IN
OUT
Set-top box
OUT
Connecting a cable / satellite set-top box, Blu-ray
Disc™ / DVD recorder via composite connectors and
analog audio
Do not place your recorder too close to the screen because some
recorders can be susceptible to signals from the TV.
RF cable
IN
RF cable
Video + Audio
(L/R) cables
IN
Note(s)
If you have any question about the DTV's antenna, visit
●
www.antennaweb.org for further information.
Depending on your antenna system, you may need different types of
●
combiners (mixers) or separators (splitters) for HDTV signal. The
minimum RF bandpass on these devices is 2,000MHz or 2GHz.
For your safety and to avoid damage to this unit, please unplug the RF
●
coaxial cable from the antenna input jack before moving the unit.
If you did use an antenna to receive analog TV, it should also work for DTV
●
reception. Outdoor or attic antennas will be more effective than a set-top
box or inside antenna.
To turn on your reception source easily between antenna and cable, install
●
an antenna selector.
If you are not receiving a signal from your cable service, contact the cable
●
provider.
Refer to the Quick start guide that shows the connections for the HDMI or
●
component input mode.
Plugging in the AC power cord
Make sure all the necessary connections are made before the AC
power cord is plugged into an AC outlet.
Caution(s)
Connect the analog audio signal cables from the external device to the analog
●
audio L/R input jacks.
If you have an amplifier, connect the HDMI cable to the HDMI input via your
●
amplifier.
Note(s)
Each time you plug in the AC power cord, no operations will be performed
●
for several seconds. This is not a malfunction.
11
.
English
Satellite
Cable
Cable
IN
Set-top box
IN
OUT
OUT
Video +
Audio(L/R)
cables
IN
OUT
Blu-ray Disc™ /
DVD recorder
Continued on next page.
Advertisement
Table of Contents
