Do you have a question about the DR101 and is the answer not in the manual?
Questions and answers
Summary of Contents for Rosco DR101
Page 1
DR101 / DR102 NFC DRIVER ID READER/WRITER USER MANUAL...
Page 2
TABLE OF CONTENTS DR101 NFC Driver ID Reader/Writer with RS232 Connection ....3 DR102 NFC Driver ID Reader/Writer with USB Connection ....3 Device Installation .
Page 3
DR101 /DR102 DEVICE DESCRIPTION PART NO. DESCRIPTION NFC DRIVER ID READER/WRITER, RS232 CONN, 10 FT CBL, FOR DR101 DV440 NFC DRIVER ID READER/WRITER, USB CONN, 3 FT CBL, FOR PC USE DR102...
Page 4
INSTALLATION Clean the ABS flat surface with an alcoholic wipe and let it dry. Remove the liner from the 3M tape on the bottom of the DR101. Place the device on the flat surface. Route the wire to connect to the RS232 port on the DV457.
Page 6
Rosco Vision Systems DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION ® DV440 WITH DR101 Driver ID Reader/Writer Operating with DVXC4 • When the installation is completed, turn on the DVXC4. • Swipe an applicable ID card/tag on the surface of the device. A successful swipe yields 1 beep, a card failure yields 3 beeps.
Page 7
DR101 /DR102 DEVICE TECHNICAL SPECIFICATIONS DR101/ DR102 Dimensions W x H x D: 61 x 80 x 26 mm Weight: 150g Cable Length: DR101: DR102: Voltage Input: +/- 5V DC Operation Distance: 3 cm Interface Level: Standard RS232 Signal Level Interface Level: RS232 Connection: Micro-Fit 3.0 Plug Molex...
Page 8
Rosco Vision Systems DUAL-VISION XC4 RECORDING SYSTEM W/ DRIVER IDENTIFICATION ® Certification FCC ID: 2AEDLDR1002020 IC: 25914-DR1002020 FCC STATEMENT Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and; (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the DR101 and is the answer not in the manual?
Questions and answers