Adjusting The Feet; Electrical Connection - Beko HTV8744X001 User Manual

90 cm
90 cm
min.40
• Connect the hose to a minimum height of
40 cm and a maximum height of 90 cm.
• If the hose is run along the floor (or at less
than 40 cm above it) and raised later on,
water drain becomes difficult and laundry
may come out extremely wet. Therefore,
observe the heights described in the figure.
• To prevent flowing of dirty water back into
the machine and to allow for easy discharge,
do not immerse the hose end into the dirty
water or do not drive it in the drain more
than 15 cm. If it is too long, cut it short.
• The end of the hose should not be
bent, it should not be stepped on
and the hose must not be pinched
between the drain and the machine.
• If the length of the hose is too short, add an
original extension hose. Length of the hose
may not be longer than 3.2 m. To avoid water
leak failures, the connection between the
extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.

3.6 Adjusting the feet

12 / EN
90 cm
90 cm
a) Loosen the lock nuts on the feet by hand.
b) Adjust the feet until the product stands level
c) Tighten all lock nuts again by hand.

3.7 Electrical connection

Connect the product to a grounded outlet
protected by a 16 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with
• The wiring for the electrical outlet circuit
• Power cable plug must be within
• If the current value of the fuse or breaker
90 cm
A
CAUTION!
• Adjust feet so that the product will be
balanced in the location it will be used.
• Balance the machine by adjusting the feet.
• Check for any play by pressing the product
from upper diagonal edges.
• Otherwise, the product may move from
its place and cause crushing, noise and
vibration problems.
• Do not use any tools to loosen the lock
nuts. Otherwise, the lock nuts may get
damaged.
and balanced.
national regulations.
must be sufficient to meet the appliance
requirements. Use of a Ground Fault Circuit
Interrupter (GFCI) is recommended.
easy reach after installation.
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
Washer-Dryer / User Manual