Epson Stylus Color 600Q User Manual page 87

Note:
You may exit default setting mode any time by turning off the printer. Any changes you made remain in effect
until you change them again.
Command List
ESC/P 2 control
codes
General operation
Paper feeding
Page format
Print position
motion
Font selection
Font enhancement
Spacing
Character handling
Bit image
Graphics
Color
Printing mode
-
4. Press the load/eject button to print the default font and
character table and the next page of instructions.
The instruction sheet lists all of the fonts and character tables
you can select.
5. Select the font and character table you want to use.
6. Exit the default setting mode by turning off the printer.
If you want to check the current default font and character table,
enter the default setting mode again and print the current settings,
which are indicated by arrows.
This section lists the available printer commands by topic. Your
printer works with the following commands.
Selecting EPSON ESC/P 2 printer in your software allows you to
use the most advanced font and graphics handling available. See the
ESC/P Reference Manual for details.
ESC@, ESC U, ESC EM
CR, FF, LF, ESC 0, ESC 2, ESC 3, ESC +
ESC ( C, ESC C, ESC C0, ESC Q, ESC l, ESC ( c, ESC N, ESC O
ESC $, ESC \, ESC ( V, ESC ( v, ESC D, HT, ESC B, VT, ESC J
ESC k, ESC x, ESC X, ESC P, ESC M, ESC g, ESC p, ESC 4, ESC
5, ESC E, ESC F, ESC !
ESC W, DC4, SO, DC2, SI, ESC w, ESC G, ESC H, ESC T,
ESC S, ESC -, ESC ( -, ESC q
ESC Space, ESC c, ESC ( U
ESC t, ESC ( t, ESC R, ESC %, ESC &, ESC :, ESC 6, ESC 7,
ESC ( ^
ESC *
ESC ( G, ESC ., ESC ( i, ESC ( e, ESC ( \, ESC ( s
ESC r, ESC ( r
ESC ( K
A-9
Specifications