Inca 8712F Instruction Leaflet

Commissioning
• Push the terminal block up into the tube.
• Locate the product in position and fit the screws to secure in place.
• Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Fitting/Replacing Bulbs
This system contains non-replaceable parts and cannot be serviced.
Care and Cleaning
Do not use solvents or abrasive cleaners as these could damage the finish.
In normal circumstances, stainless steel is very resistant to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse
with clear water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left behind
after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
However if the product is subject to extreme environmental conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should be carried out around four times a year. For severe corrosion,
non-abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the corrosion. Wash
and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
Do not clean the units with a pressure washer.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
The LEDs are protected by a glass shade. The shade cannot be replaced, if the shade becomes cracked or damaged,
this fitting must be discarded.
This product contains a light source of energy efficiency class F.
UK Manufacturer: EU Manufacturer:
BH17 7BY 1 Gnarrenburg, 27442
Instruction leaflet
Inca LED Outdoor Light Post
8712F
20/09/2021