D-Link DCS-8627LH User Manual page 22

Section 3 - mydlink
1 Device Photo
2 Device Name
3 Device Location
4 Time Zone
5 Wi-Fi
6 Designated Contact
7 Camera Microphone
8 Motion Setting
9 Color Night Vision
10 Spotlight
11 Siren
12 Anti-Flicker
13 Privacy Mode
14 Status LED
15 Storage
16 Firmware Update
17 Current Firmware Version
18 Device ID
19 Remove Device
D-Link DCS-8627LH User Manual
Tap to add a customized photo of this device.
Tap to change the device's name.
Tap to change or add a new location for this device.
Select the time zone to calibrate your device to.
Tap to change the wireless network this device will use to connect
to the Internet. Note: The network must be the same as all your
other mydlink devices that you wish to use the same account for.
Tap here to add, remove, or edit designated contacts that appear in the
rich notification.
Tap to enable or disable picking up sound near your camera in live view
and recordings.
Tap to further configure sensitivity and the active area of motion
detection.
Tap to enable Color Night Vision.
Set the auto-off timer for the spotlight. This setting will apply to manual
operation and Automations.
Set the auto-off timer for the siren. This setting will apply to manual
operation and Automations.
Reduces flicker in the video. Tap 50 Hz or 60 Hz depending on the frequency
of your lights.
Tap to enable. Privacy mode will disable the camera feed.
Disabling this will turn off the LED until you turn it back on.
Tap to change video clips storage location from the microSD card to the
cloud. You can also subscribe to mydlink Cloud from here and view your
current subscription plan.
Shows time of auto firmware update. Tap to enter the update settings. You
can choose the most suitable time for automatic updates.
This displays your devices' firmware version.
Identifies the device for support issues.
Tap this button to disconnect this device from your mydlink account.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
19