Trouble-Shooting - Aiwa AW-LED50X8FL Operation Manual

Caution: when you clean the screen, hold the device steady with one hand
and carefully clean the screen with the other. Otherwise, the device could tip
over and get damaged or cause injuries.
Storage when not in use
If you do not plan to use the device for an extended period of time, unplug the power cord from
the socket and remove the batteries from the remote control. Make sure that the storage
temperature is between -15 °C and 45 °C and the relative humidity does not exceed 90%.
Transport
If you wish to move the device a short distance, proceed as follows to transport the device:
1. Disconnect the device from the mains.
2. Remove all cables connected to the device.
3. If you wish to move the device outside your building, demount the base and the optional
side supports or the mounted wall bracket by reversing the procedure.
4. Pack the TV set up carefully. Take special care to ensure the corners of the casing and
the screen are well protected.
5. Take the TV set and its accessories to its new location and recommission it.
Disposal of old electrical appliances
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must
not be disposed of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimize the recovery
and recycling of the materials they contain, and reduce the impact on human
health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your
obligation, that when you dispose of the appliance, it must be separately
collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.

Trouble-shooting

You can solve most common problems yourself using the solutions below. If the
problem persists after checking the suggested solutions, please contact your reseller.
General problems
The TV set will not switch on.
•
Plug the power cable of the TV set into a working mains socket.
•
Replace the batteries in the remote control.
•
Unplug the plug of the power cable from the mains socket, wait approx. 30 seconds and
plug the power cable back in. The device should then work normally.
The remote control does not work
•
Is there an obstruction between the remote control and the sensor on the TV?
•
Replace the batteries.
•
Make sure that the remote control sensor is not exposed to direct sunlight.
13