Epson Stylus C80 Printer Basics Manual page 52

Set the paper thickness lever to the
I
position. Set the lever to the ^
m
position when you print on thicker
paper or envelopes. You may also
need to turn off
printer software.
Your printout is blurry or smeared.
Make sure your paper isn't damp or
I
curled, or loaded face down (the
printable side should be face up).
Use a support sheet with special
I
paper, or try loading your paper
one sheet at a time.
in the
High Speed
Make sure your paper meets the
I
specifications listed in the on-screen
Reference Guide, and that it's
compatible with your printer. Use
plain paper or one of the media
types listed on the inside back
cover.
Use EPSON papers to ensure
I
proper saturation and absorption
of genuine EPSON inks.
Non-EPSON media may not be
compatible and may produce ink
bleeding or pooling.
Run the Print Head Alignment
I
utility. See page 34 for instructions.
Check the paper thickness lever
I
position. If it's in the
your printer is set for thicker
paper or envelopes and your image
may smear. For most papers, set
the paper thickness lever to the
m
position, as shown to the left.
Remove each sheet from the output
I
tray after printing, especially when
you're printing on transparencies.
Let your print dry completely
I
before you handle it. Prints made
on Premium Glossy Photo Paper or
Premium Semigloss Photo Paper
take longer to dry. Follow the
instructions included in your media
pack.
^
position,
47