Oncam EVO-12-NMD Quick Start Manual

Evolution 12 Outdoor Camera
QUICK START GUIDE
Important
• Read these instructions carefully before installing
or operating this camera.
• This camera should be installed by a qualified
service person and the installation should
conform to local and national regulations.
• This camera is not suitable for installation in
a ceiling void that is used as an air handling
space.
• Certified as FCC Class A. In a domestic
environment this camera may cause radio
interference in which case the user should take
adequate measures.
DANGER: RISK OF EXPLOSION IF
REPLACING A BATTERY WITH AN
INCORRECT BATTERY TYPE.
Welcome
The Oncam Evolution 12 Outdoor 360° camera is
designed to be connected to an IP network. Configure and
operate the camera using a standard internet browser.
Described are the installation and configuration
procedures for a standard surface mount camera
application.
Power Input
Operating
Temperature
Enclosure
Weight
Supplied Parts
EVO-12-NMD
• EVO-12 Camera
• Base Assembly
• Trim Cover
Technical Support
For the A&E, Specification, Installation and User Manual,
Software and Firmware visit:
www.oncamgrandeye.com/resources/product-downloads/
Tel: UK +44 (0)20 7371 6640
US +1 978 735 4860
Email: support@oncamgrandeye.com
MAC Address
Document the camera's installation location and unique
MAC address. Find the MAC address printed on the
camera label. This information may be needed during the
camera configuration.
12 VDC, 1.0 A (min) LPS or NEC Class 2 power
supply or Power over Ethernet (PoE),
IEEE standard 802.3af
-40 to +55°C (-40 to +131°F)
Aluminum with polymer bubble
1.12 kg (2.47 lbs)
• Security Screw Driver Bit
• Quick Start Guide
• Drilling Template
Installation & Mounting
The Evolution Outdoor Dome camera is IP-66 rated and
vandal resistant.
The wire grommets on the back are sealed until
perforated by the installer. The integrity of these seals
are essential in order to keep moisture from entering
the enclosure. Carefully pierce the seals to ensure the
integrity of the seal around the cable.
Configure cabling to enter the camera from the side or
rear of the mounting base. Routing cabling from the rear
is recommended where possible to offer improved vandal
and tamper resistance.
Preparation
1. Puncture the diaphragm of the grommet by using a
sharp tool.
2. Pass a round Ethernet cable (CAT5 or better) through
a 20 mm compression cable gland. If using the side
entry or one of the rear rubber grommets, gently pull
the cable through the grommet to help secure the
seal.
NOTICE: Secure the cable to prevent movement.
3. Prepare the wires in accordance with EIA 568B
standards for crimping (RJ45 connector not
supplied).
Installation
1. Using the drilling template,
attach the Base Assembly to
the surface with the four holes
located outside the trim ring
seal joint.
Note: Use hardware
appropriate for the mount
surface to support a minimum of four times the
weight of the camera and enclosure.
2. Remove the alarm connector (if necessary).
3. Pass the Ethernet cable around the camera, securing
the cable into position.
4. Attach the Camera Module and route cables.
5. Rotate the Camera Module
into the mounting clip in the
Base Assembly.
6. Fasten the Camera Module
in place with the captive
thumb screw.
7. Assemble the Trim Cover
using the four captive
security screws.