Advertisement
ASSEMBLY INSTRUCTION
1
3
4
DISASSEMBLY INSTRUCTIONS
To remove the Seat Top from the Support Cylinder, turn the stool upside
down, and strike the edge of the Support Cylinder several times where it
meets the support. The Support Cylinder and Base Plate and Leg will
separate with applied force.
1. Use a hex wrench to attach the Base Plate
and Leg to the underside of the chair seat with
the provided hex bolts.
2A. A Black Cap protects the hydraulic
mechanism on the Support Cylinder.
2B Remove the Black Cap and discard it
before assembly. The Orange hydraulic
button will become visible.
3. Insert the Support Cylinder into the Base
Plate and Leg and press firmly.
4. Set the Foot Cap over the hole in the
Base. Insert the thicker end of the Support
Cylinder into the center hole of the Base,
and press down FIRMLY.
5. Guide the open end of the barstool assembly
over the Support Cylinder and firmly press down
on the seat.
To raise the barstool, grasp the Handle and pull upward without applying any
weight. To lower, raise the handle upward and apply weight to the seat.
Turn the stool upside down. Hit the Metal Clip
several times located in the exact center of the
bottom of the Base with a rubber mallet to
disengage the locking mechanism. The Base will
separate from the Seat Top and Support Cylinder.
2A
2B
5
Metal Clip
Advertisement
