Do you have a question about the SEISMIC MT 1:18 4WD RTR MONSTER TRUCK and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Revolution SEISMIC MT 1:18 4WD RTR MONSTER TRUCK
Page 1
INSTRUCTION MANUAL RVOS01000 MANUEL D’UTILISATION RVOS01001...
Page 2
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. MEANING OF SPECIAL LANGUAGE The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a high probability of superficial injury.
® • 2.4GHz Transmitter (ECX10003) • 100mA 9V AC-Input Charger with EC3™ Connector (DYNC1030) • 900mAh Dynamite Speed Pack with EC3™ Connector (DYN1462) ® • 2-in-1 Revolution Receiver/ESC (RVOS11001) ® • 370 Revolution Brushed Motor (RVOS11000) ® • AA (4) Batteries QUICK START Please read the entire manual to gain a full understanding of the vehicle, fine-tuning the setup and performing maintenance.
VEHICLE PREPARATIONS CHARGING THE VEHICLE BATTERY • Read all safety precautions and literature prior to use of this product. • Never leave the battery and charger unattended during use. NOTICE: Never charge a battery in the vehicle or damage may result. • Never allow children under 14 years of age to charge battery packs.
TRANSMITTER CONTROLS BATTERY LEVEL INDICATOR Solid Red: Battery voltage is good (above 4V) Blinking Red: Battery voltage is critically low (below 4V). Replace transmitter batteries. REVERSE THROTTLE TRIM SWITCH Adjusts the neutral point of the electronic speed control Allows you to change the direction of steering (ST.
GETTING STARTED 1. Power on the transmitter. 3. Perform a test of the transmitter’s control of the vehicle with the 2. Connect the battery to the receiver and power on the vehicle. vehicle’s wheels off the ground. 4. Start driving slowly, and, if the vehicle does not go straight, adjust the steering trim dial on the transmitter.
MOTOR CARE • Seat the motor brushes by driving smoothly on a flat surface continuously up hill. Allow the motor to cool completely during use of the first battery charge. Failing to do so can before running the vehicle. greatly reduce motor performance and functional life. • Over-temperature protection is installed on the ESC to prevent • Prolong motor life by preventing overheating conditions.
Limitation of Liability http://www.horizonhobby.com/content/service-center_render-service- HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL center. If you do not have internet access, please contact Horizon Product OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION Support to obtain a RMA number along with instructions for submitting your OR COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH product for service.
Replacement Parts List • Liste des pièces de rechange Part Number English Français DYN1462 7.2V 900mAh NiMH Battery, EC3 Batterie NiMH 900 mAh 7,2 V, EC3 RVOS11000 370 Motor, Brushed: 1/18 Seismic Moteur 370, à balais : Seismic à échelle 1/18ème RVOS11001 Receiver/ESC, Servo: 1/18 Seismic Récepteur/ESC, Servo : Seismic à...
Need help?
Do you have a question about the SEISMIC MT 1:18 4WD RTR MONSTER TRUCK and is the answer not in the manual?
Questions and answers