Rotel RX-1052 Technical Manual page 10

Hide thumbs Also See for RX-1052:

1. Light-up ALL FL segments to check:

Press "SPEAKER B" and "BAND" of front panel while turn on the rear panel master

power switch. When release the lighting, press STANDBY switch or master power switch.

2. Default Setting:

Press "SPEAKER B", "TUNE/PRESET" and "MONO" buttons together. The front panel

display shows setting mode of "BAND". The "CD" as UP, "VIDEO 2" as LEFT, "VIDEO 3" as

DOWN and "VIDEO 4" as RIGHT is used for the cursor buttons.

a) Shown "BAND" and "USA" or "EUR" in the display window. Select by "VIDEO 2" and

"VIDEO 4" to set the destination.

b) Press "VIDEO 3" for next setting, shown "POWER" mode with "STANDBY",

"DIRECT" and "ALWAYS-ON" and select by "VIDEO 2" and "VIDEO 4" buttons. The

Default is ""STANDBY".

c) Press "VIDEO 3" for next setting, shown "Z[X] MAX" of Zone[2, 3, 4] maximum

volume level setting using front panel volume knob. The Default is "Maximum".

d) Press "VIDEO 3" for next setting, shown "Z[X] T-ON" of Zone[2, 3, 4] turn-on volume

level setting using front panel volume knob. The Default is "60".

e) Press "VIDEO 3" for next setting, shown "Z[X] VOL" of Zone[2, 3, 4] volume control

with fixed or variable setting select as "FIX" or "VARI" by "VIDEO 2" and "VIDEO 4"

buttons. The Default is "VARI".

f) Press "VIDEO 3" for next setting, shown "SAVE" mode with "NO" or "YES". Select

by "VIDEO 2" and "VIDEO 4" buttons. If it is selected "YES", the unit goes to normal

mode besides the saved setting. If it is selected "NO", it will be display "EXIT" with

"NO" or "YES" and select by "VIDEO 2" and "VIDEO 4" buttons. If it is selected

"YES", the unit goes to normal mode without save the setting. If it is selected "NO", it

will be display "BAND" again.

g) After saved setting, the custom labels are also deleted as a default setting.

<MEMO>

RX-1052v03

Table of Contents