Advertisement
5. OPERATION
5.1.
MOUNTING HEADSTOCK PINS.
5.1.1.
Fix shaft (fig.1F) firmly into head using M8 capscrew. (fig.1E).
5.1.2.
Select relevant headstock pin pack (fig.1G) to suit bike headstock diameter. Ensure full engagement of pin pack to headstock.
5.2.
ADJUSTING THE HEIGHT OF HEADSTOCK LOCATING PIN.
5.2.1.
The upper frame of the stand (fig.1A) can be height-adjusted by means of four different locking positions on lower frame arms (fig.1B).
5.2.2.
Remove the 'R' clips from the upper frame pins (fig.1C) and withdraw pins.
5.2.3.
Slide the upper frame over the lower frame arms to set the required height by locating the relevant mounting hole position.
5.2.4.
Re-insert pins and fix in place with the 'R' clips.
5.3.
LIFTING THE FRONT WHEEL.
WARNING: Before using the stand ensure that the cap screws which lock the frames in position (fig.1D) are fully engaged in the hinge
‰
tube.
NOTE: We advise seeking the assistance of a second person when mounting / dismounting the stand.
5.3.1.
With the bike well supported, move the stand into position and locate the headstock pin into the headstock.
5.3.2.
Lever the frame downwards in a controlled manner until it lays on the floor. This will lift the bike's front wheel off the ground.
If the wheel is not lifted sufficiently lower the stand and select the next locking position (See 5.2).
5.3.3.
Check that the motorcycle is stable while elevated before leaving it.
fig.1
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
F
G
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
FPS5.V2
Issue 1 03/04/18
Advertisement
