Getting Started - Aiwa AW-LED50X6FL Operation Manual

Getting started

Fitting the stand
Before you can install your TV set, you need to fit the stand. Alternatively, you can mount it
on the wall. A Phillips screwdriver is needed to perform the installation.
Setting up the TV set
Place your TV set on a flat, stable surface (e.g. a table or a specially designed TV stand).
Make sure that all cables are laid simply and safely and do not represent a trip hazard. The
device must be connected to a mains socket using the mains cable. This mains socket must
be easily accessible so that the mains plug can be removed immediately in the event of an
emergency.
Fitting the batteries into the remote control
1. Turn the remote control over with its underside facing upwards, insert a finger into the
recess, and push the battery compartment cover in the direction of the arrow. Remove
the battery compartment cover.
2. Insert the batteries supplied into the remote control. Make sure that you insert the
batteries correctly with the polarity as shown inside the battery compartment.
3. Replace the battery compartment cover and push in the opposite direction to the arrow
until it clicks into place.
Notes on Using Batteries:
The use of the wrong type of batteries may cause chemical leakage and/or explosion.
Please note the following:
 Always ensure that the batteries are inserted with the + and - terminals in the correct
direction as shown in the battery compartment.
 Different types of batteries have different characteristics. Do not mix different types.
 Do not mix old and new batteries. Mixing old and new batteries will shorten battery
life and/or cause chemical leakage.
 Replace batteries as soon as they do not work.
 Chemicals which leak from batteries may cause skin irritation. If any chemical matter
seeps out of the batteries, wipe it up immediately with a dry cloth.
 The batteries may have a shorter life expectancy due to storage conditions. Remove
the batteries whenever you anticipate that the remote control will not be used for an
extended period.
 The batteries (battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
CAUTION:
 It may result in an explosion if batteries are replaced incorrectly.
 Only replace batteries with the same or equivalent type.
8