Advertisement
Quick Links
Advertisement
Related Manuals for ROA HOBBY Parkour 280
Summary of Contents for ROA HOBBY Parkour 280
- Page 1 ROA HOBBY(HK) LIMITED 三源电子（香港）有限公司...
- Page 2 ROA HOBBY(HK) LIMITED 三源电子（香港）有限公司 280穿越机调参指导书...
- Page 3 Binding ： 1：Please turn the “ELE” switch to the “REV” position (as picture 1 shown) Picture 2：Connect the binding cable to the “BAT” port of receiver (as picture 2 shown) Picture 2 3：Connect the aircraft and battery (as picture 3 shown ) Picture 3 4：Press and hold the bind key of the transmitter and turn the transmitter power on(as picture 4...
- Page 4 Specification Setting ： 1：After blinding process finished, connect the aircraft battery and turn the transmitter power switch on (please make sure the signal between the transmitter and aircraft is connect). Then using USB connect the computer and aircraft. 3：将对码条插入:”BAT”的端 Attention： 口。如图：...
- Page 5 参数调整： Attention： If the signal between transmitter and computer disconnect, the TX and RX area shown on the computer is grey. If connect, when you push the left /right stick .the moving of stick will shown on the computer(as red circle shown). 。...
- Page 6 If mode 2, please select “Yaw left” and then tick "save"...
- Page 7 Click ”OUTPUT” to enter into motor test...
- Page 8 After tick "TEST OUTPUTS", a dialog will pop up, please click “Yes”. Before test the motor, please tick the “Test outputs”...
- Page 9 After finished motor test (M1-M2- M3-M4 ), please save it.
- Page 10 After motor test finished, , please tick the " Test outputs" and then save it.
Need help?
Do you have a question about the Parkour 280 and is the answer not in the manual?
Questions and answers