Sitting Vision Relax4U Manual page 8

2.4
Operating the armchair (with the lift/with the footrest) using the fingertip
controls in the arm or seat panel.
Your armchair has 3 motors and a stand-up function, but no extra option. Your control panel
has 3 keys.
Each key has a dual function (Function F1 and F2): Pressing a key will cause a motor to move.
The motor will move in the opposite direction if you release the key and press it again.
The front key (1 - footrest) is for operating the footrest. The footrest will unfold when you
press the key; the armchair will move further into the heart balance once the footrest is
fully unfolded. Release the key for a minimum of 2 seconds and press this again to move the
heart balance function and footrest back again.
The centre key (2 - lift) is for operating the lift function. This will allow you to bring the arm-
chair into its stand-up position.
Release the key for a minimum of 2 seconds and press this again to return the armchair to
its neutral position.
The rear key (3 - back) is for operating the back. Pressing the key will move the backrest
backwards. Release the key for a minimum of 2 seconds and press this again to move the
back forward again.
Press the two keys (2+3) at the same time to activate the heart balance function
tilt the armchair in its entirety; the footrest and back will remain the same position relative
to each other. Release the keys for a minimum of 2 seconds and subsequently press the 2nd
key to return the heart balance function back to the neutral position.
The stand-up function can only be operated with a closed footrest and the back in an upright
position.
--- 7 ---
This will
.